2) Does CATIA support a zero radius fillet on a closed edge? Please refer to the figure below:

a) No, CATIA does not support a 0 radius fillet
b) Yes
c) Yes, it supports but not on closed edges
d) Yes, it will but only if number of points for variable radius are more than 4

3) In which release of CATIA V5 we can use the Hole tool to directly place hole on the curved or cylindrical surface.

a) CATIA V5R17
b) CATIA V5R16
c) CATIA V5R15
d) All of these

4 ) What is the environment variable required to Get the tool Convert CATProduct to CATPart in the Tools pull-down menu of CATIA V5 R12.

a) CATPRODUCT_TO_CATPART = 1
b) IRD_PRODUCTTOPART = 1.
c) PRODUCT_TO_PART = 1
d) CONVERT_PRODUCT_TO_PART = 1

5)         Which Product / Configuration mentioned below has the capabilities of Draft Both Sides & Auto Fillet (Refer the below figure).

a) CATIA – Extended Mechanical Design 2 (XM2)
b) CATIA – Functional Molded Part 2 (FMP)
c) CATIA – Cast & Forged Part Optimizer (CFO)
d) CATIA – Generative Shape Optimizer (GSO)